English
27
Clock/Timer
5 Press S / T (or TITLE +/- (í / ë) on
the remote control ) repeatedly to set the
minute for the timer to start.
6 Press SLEEP/TIMER on the remote control to
store the start time.
● At the preset time, the selected source will play.
To exit without storing the setting
● Press Çon the system.
Notes:
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no button is pressed
within 60 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
● In standby or view clock mode, press SLEEP/
TIMER on the remote control.
➜ disappears from the display.
To activate the TIMER
● In standby or view clock mode, press SLEEP/
TIMER on the remote control.
➜ appears on the display.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1 In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜ The selections are as follows (time in
minutes):
90 ™ 75 ™ 60 ™ 45 ™ 30 ™ 15 ™ OFF ™
90…
2 When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
➜ is shown, except for "OFF" mode.
➜ The sleep timer is now set.
To check the remaining length of time
after sleep timer is activated
● Press SLEEP/TIMER once.
To change the preset sleep timer
● Press SLEEP/TIMER again while the remaining
sleep timer is shown.
➜ The display will show the next sleep timer
options.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press B.
Note:
– will start flashing when the remaining
length of time after activation of the sleep timer is
less than 1 minute.
FWM996_85_Eng 9/18/08, 16:1127
To Next Page
Loading...
