Philips FX10X/78 - Other Features; Set the Alarm Timer; Set the Sleep Timer

17EN
9 Other features
Set the alarm timer
This unit can be used as an alarm clock. You can
select disc, radio or USB as alarm source.
1 Make sure that you have set the clock
correctly.
2 Press and hold SLEEP/TIMER for more
than two seconds.
» 'TIMER SET' is displayed. Then, a
prompt to select the sound source is
displayed.
3 Press SOURCE to select a source from
DISC, USB and FM, then press SLEEP/
TIMER to conrm.
» The hour digits are displayed and begin
to blink.
4 Press / repeatedly to set the hour,
then press SLEEP/TIMER to conrm.
» The minute digits are displayed and
begin to blink.
5 Press / repeatedly to set the minute,
then press SLEEP/TIMER to conrm.
» A prompt to select the volume level is
displayed.
6 Press +/- to select the desired volume
level, then press SLEEP/TIMER to conrm.
» The alarm timer is set and activated.
To deactivate or re-activate an alarm timer
• In standby mode, press SLEEP/TIMER
repeatedly.
» When the alarm timer is deactivated,
''TIMER OFF is displayed.
» When the alarm timer is re-activated,
'TIMER ON' is displayed.
Tip
• In BT, AUDIO IN or AUX IN mode, the alarm timer
cannot be set.
• If the disc or USB source is selected but no audio le
can be played, FM radio is activated automatically.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
• When the unit is turned on, press SLEEP/
TIMER repeatedly to select a set period of
time (in minutes).
To deactivate sleep timer
• Press SLEEP/TIMER repeatedly until [OFF]
(off) is displayed.