35
PTZ
Access to the AutoDome may be password protected. See AutoDome Security for details.
To use Locked Commands, you must first unlock the AutoDome by entering "Off-90-
Enter." All locked settings, except FastAddress, can then be changed via "On-46-Enter."
Disallow these commands by pressing "On-90-Enter."
Commands Keystrokes Description
FastAddress On-999-Enter Sets/changes the dome address using the keyboard
and on-screen menus.
Display FastAddress On-997-Enter Briefly display all dome addresses.
Auto Iris On/Off-3-Enter Camera (iris) adjusts automatically/manually
(On/Off) to light conditions.
Auto Focus On/Off-4-Enter Camera will automatically/manually
(On/Off) focus.
Gain Control On/Off-43-Enter Turns gain control to Automatic or Off. This is use-
ful with dark scenes.
On-screen Display On/Off-60-Enter Turns On/Off the On-screen Display. When off,
there is no On-screen feed back.
On-screen On/Off-61-Enter Changes the characters and position
Display Adjust of the display. On-screen instructions are provided.
Zone Title Edit On/Off-63-Enter Edits the current Zone name.
On-screen instructions are provided.
Zone Masking On-86-Enter Masks video from being displayed
in selected zones.
Lock/Unlock On/Off-90-Enter Allows/Disallows locked commands to be accessed.
Commands
Password Set-802-Enter Sets or displays password. See the AutoDome
Security section for details.
Factory Home Set/-110-Enter SET recalibrates camera and returns it to “home”
Position position.
Restore Defaults On-40-Enter Restores Factory Defaults.
SETUP GENERAL
Commands Keystrokes Description
Left Limit Set-101-Enter Sets the current position as the left limit of Auto
Pan. Default is 0 degrees.
Right Limit Set-102-Enter Sets the current position as the right limit of Auto
Pan. Default is 359.9 degrees.
Inactivity On/Off-9-Enter Selects the mode that the dome will revert to after a
duration without operator activity. Default is OFF.
Preset On/Off-15-Enter Increase/Decrease (On/Off)
Tour Period the time between Presets during Preset Tour.
AutoPivot On/Off-18-Enter Lets you follow a subject travelling beneath the cam-
era without inverting the picture. Default is ON.
Select On/Off-35-Enter Adjusts camera color (white balance)
White Balance or On/Off-30-Enter for specific settings.
Sharpness On/Off-44-Enter Picture (vertical aperture) will sharpen/soften.
Auto Iris On/Off-10-Enter Adjusts the light levels for brightest/average
ALC Detector (On/Off) parts of the scene. N/A on Day/Night.
Iris Adjust On/Off-11-Enter Edits the Auto Iris level.
Sync Mode On/Off-42-Enter Sets camera sync for external-line/internal-crystal
(On/Off).
Adjust Line On/Off-41-Enter Change the phase delay of the camera
Lock Phase when in external line lock mode.
Switch Polarity On-91-Enter Switch the polarity of the Zoom, Focus and Iris
controls.
Night Threshold Adj. On-58-Enter Selects the video level at which the camera will switch
to night mode (Day/Night only).
QuickSet Select On-59-Enter Lets you pick one of several modes where multiple
camera settings are set according to the chart below
(Day/Night only).
CAMERA
AUTODOME
LOCKED COMMANDS
QuickSet Gain Slow
Mode Name Control IRIS Shutter IR Filter
Low Light Color Auto Auto Auto In
Full Auto w/ Slow Shutter Auto Auto Auto Auto
Full Auto w/o Slow Shutter Auto Auto 1/60 Auto
Night w/ Slow Shutter Auto Auto Auto Out
Night w/o Slow Shutter Auto Auto 1/60 Out
To Next Page
Loading...
