5
STEP
A1
Pendant/EnviroDome
Carefully remove the G3 AutoDome
®
from the box.
The unit is shipped with the lower and upper housings
connected only by the safety cable. DO NOT
STRESS THE CABLE WHEN UNPACKING
THE AutoDome. Save all packing material, as it can
be used for setting up the camera and for transporting
the dome.
STEP
A2
Place the upper half of the G3 AutoDome into the star
shaped foam and remove all packing material. Make sure
to remove all debris that may interfere with the camera.
If an item appears to have been damaged in shipment,
replace it properly in its carton and notify the shipper. If
any items are missing, notify your Philips
Communication, Security & Imaging Sales
Representative or Customer Service Representative.
NOTE: Section A applies to the EnviroDome & Indoor Pendant.
Photos show the EnviroDome.
Installation Guide
To Next Page
Loading...
