37
NOTE: The following four (4) Camera Setup options refer to Day/Night models only
and will not appear on the screen otherwise.
Night Mode – Selects night mode (B/W) operation (Day/Night models only).
Choices: . . . .On, Off,Auto (AGC must be ON for auto-night mode to work prop-
erly. Note: Manual iris control is not possible while in Night mode).
Night Mode Threshold – Adjusts the level of light at which the camera will auto-
matically switch to night mode (B/W) operation (Day/Night models only).
Choices: . . . .Sliding Scale from 0 to 20.
Night Mode Color – Determines if color processing remains in effect while in
night mode (Day/Night models only).
Choices:
On . . . . . . . . .Color burst remains in video signal. Picture will have a greenish
shade of B/W.
Off . . . . . . . . . .Video is true B/W without color burst in video signal.
QuickSet Mode – Selects one of several modes where camera settings are set
according to the preceding AutoDome Locked Commands chart (Day/Night
models only).
LENS SETUP
(See Figure AM2 for an illustration of the Lens Setup menu hierarchy).
Auto Focus – G3 AutoDome automatically focuses on the subject in the center of
the screen. The factory default* setting is SPOT.
Choices:
Constant . . . . .Auto Focus is always active, even while moving.
Manual . . . . . . . .Auto Focus is inactive, manual focus must be used.
*Spot . . . . . . . . .Auto Focus activates after the camera stops movement, once
focused,Auto Focus is inactive until camera is moved again
Auto Iris – G3 AutoDome automatically adjusts to varying light conditions. The fac-
tory default* setting is CONSTANT.
Choices:
*Constant . . .Auto Iris is constantly active.
Manual . . . . .Iris must be manually adjusted.
Auto Iris Level – Reduces the camera’s Iris reference level for proper exposure.
The factory default* setting is midpoint.
Choices: . . . .Sliding scale from – (reduce brightness) to + (increase brightness).
Focus Speed – Adjusts the manual focus speed.The factory default* setting is 2.
Choices: . . . .Sliding Scale from 1 (normal) to 10 (fast).
Iris Speed – Adjusts the manual iris speed.The factory default* setting is 5.
Choices: . . . .Sliding Scale from 1 (normal) to 10 (fast).
Max Zoom Speed – Adjusts the manual zoom speed.The factory default* setting
is FAST.
Choices: . . . .Fast*, Medium, and Slow.
ADVANCED MENU (Continued)
To Next Page
Loading...
