Philips H982NUD - Clock (VCR)

English
9
22 Clock (VCR)
• If the clock has never been set,
the CLOCK SET menu may
appear when you press
DISC/VCR MENU. If so, follow
the instructions from step 3
above.
•Press DISPLAY until the time
appears on the TV screen.
•Power failures of more than 30
seconds can erase the clock
setting.
•To reset the clock, follow steps
1-2. Select the information you
want to change using s or B.
When the information is
flashing, use K or L to enter
the correct information. Press
CLEAR/RESET to set the clock.
Helpful Hints
2-9
STANDBY-ON
PLAY
DVDVCR VCR/TV
OK
MENU MENU
DISC/VCR
RETURN TITLE
A-B
CLEAR/RESET SLOW
SUBTITLE ZOOM ANGLE
REPEAT REPEAT AUDIO
SEARCH MODE DISPLAY
SKIP / CH
SYSTEM
PAUSESTOP
MARKER RECORDTIMER SET
SPEED
1 2 3
7
6
5
4
8
9
0
+10
1
MONTH DAY YEAR
0 3 / – – – – – –
HOUR MINUT EAM/PM
– – : – – – –
CLOCK SET
MONTH DAY YEAR
0 3 / 2 0 – – – –
HOUR MINUTE AM/PM
– – : – – – –
CLOCK SET
MONTH DAY YEAR
0 3 / 2 0 MON 2 0 0 6
HOUR MINUTE AM/PM
– – : – – – –
CLOCK SET
Follow these steps to set the VCR clock. Make sure:
1
Press VCR, then press DISC/VCR MENU so MENU
appears. If the clock has never been set, the CLOCK SET
menu may appear when you press DISC/VCR MENU. If so,
follow the instructions from step 3 on this page.
2
Press K or L to select CLOCK SET.Then, press B.
3
While the MONTH space is flashing, press K or L
until the month appears.Then, press B.
4
While the DAY space is flashing, press K or L until
the day appears.Then, press B.
5
While the YEAR space is flashing, press K or L
until the year appears.Then, press B. The day of
the week will appear automatically.
6
While the HOUR space is flashing, press K or L
until the hour appears.Then, press B.
7
While the MINUTE space is flashing, press K or L
until the minute appears.Then, press B.
8
While the AM or PM space is flashing, press K or L
to point to AM or PM.
Your selection will flash on the screen in the AM/PM space.
9
Press CLEAR/RESET or B to start the clock.
H982NUD_EN1 3/2/06 6:56 PM Page 22