23EN
Problem Possible cause Solution
Overfl ow. A wrong function was selected. Select a correct function.
Installation was incorrect or the
perforated fl ow cup was not
installed into place.
Make sure that the perforated
fl ow cup is correctly installed.
Soymilk is too diluted or too
many beans are added.
Put proper quantity of ingredient
as instructed in the “Use the
appliance” section.
The water level is above
上水位 (the maximum level
indication) or below 下水位
(the minimum level indication).
Make sure that the water level is
between 上水位 (the maximum
level indication) and 下水位
(the minimum level indication).
The appliance is broken. Contact the Philips Consumer
Care Centre.
The overfl ow sensor is not
cleaned.
Clean the overfl ow sensor.
The time taken to
process soymilk
is longer than
instructed, but other
functions work well.
The voltage is too low. Use a household power regulator.
The water temperature is
too low.
Add warm water no hotter
than 70℃.
Food is burnt. A wrong function is selected. Select a correct function.
The inner side of the chamber
was not cleaned.
Clean the inner side of the
chamber.
Insuffi cient water is added. Make sure that the water level is
between 上水位 (the maximum
level indication) and 下水位
(the minimum level indication).
Too much ingredient is added. Put proper quantity of ingredient
as instructed in the “Use the
appliance” section.
To Next Page
Loading...
