Philips HD2151 - Floater; Pressure Regulator; Sealing Ring

23
EN
Floater
• Hold the rubber ting around the oater,
and pull outwards to remove it from
the top lid. Clean it regularly with water
and make sure there’s no food residue
sticking to it, otherwise you may encounter
diculty to open the lid.
• To assemble the oater, put the thin end of
the oater into the hole on the lid (g.1),
and assemble the rubber ring around the
oater (g.2).
1
2
• You can also add water to the pot and
start the steam function to help with the
cleaning.
Pressure regulator
• Hold the handle of pressure regulator and
pull it out gently. Rinse it under tap water
to remove food residues inside, or use a
toothpick.
• Hold the right handle of pressure regulator
and assemble it back to the inner lid.
Sealingring
Note
• Do not remove the sealing ring by force, it
will leak if not fully assembled.
• Put the sealing ring with the groove facing
upwards in a at surface.