Philips HD8828 - Rinse Phase After Descaling

64 ENGLISH
7
Pour all the descaling solution into the water tank. Then  ll the water
tank with fresh water up to the CALC CLEAN level.
8
Put the water tank back into the machine.
Descaling Phase
10
Press the “ ” button to start the descaling cycle.
Yellow
11
The machine will start dispensing the descaling solution at intervals.
The bar on the control panel shows the cycle progress. This procedure
takes approx. 20 minutes.
9
Pull out the carafe dispensing spout to the right up to the “ ” icon.
Place a large container (1.5l) under both the carafe dispensing spout
and the co ee dispensing spout.
6
Remove the “INTENZA+” water  lter (if installed) from the water tank
and replace it with the small white original one.
Yellow
CALC
CLEAN