Philips HFL4014 Series User Manual

- 10 -
2.1.4.2 How to set the multi RC for the guest RC 22AV1904A
You can use the guest RC for multi RC. More details can be found in the ‘Professional settings’ chapter.
You can program this RC by pressing 2 buttons at the same time for 5 seconds.
Below you can find a table how to match the TV settings and the settings as they can be used in the
guest RC:
Mode:
Buttons combination:
Blue (default)
“Home” and “Blue”
Yellow
“Home” and “Yellow”
Red
“Home” and “Red”
Green
“Home” and “0”
0
“Home” and “1”
1
“Home” and “2”
2
“Home” and “3”
3
“Home” and “4”
4
“Home” and “5”
5
“Home” and “6”
6
“Home” and “7”
7
“Home” and “8”
8
“Home” and “9”
9
“Home” and “0”
Note: When the battery is low, the RC will send out a special battery low command after each
key press with a notification on the display.
Note: The Multi RC setting is not permanently stored. After battery exchange the Multi RC
setting for the RC need to be programmed.
2.1.4.3 How to setup the Healthcare RC
The RC can be used in both RC5 and RC6 mode, meaning that it can be used for all TV’s. By default the
RC is in RC6 mode (for 301x/501x/701x TV’s). You can change the RC to RC5 mode (for 28x9 TV’s).
 You can change the RC to RC5 mode by pressing 5 seconds “Home” and “Volume up” at the
same time.
 You can change it back to RC6 mode by pressing 5 seconds “Mute” and ”Channel up” at the
same time.
You can also use this RC for multi RC. More details can be found in the ‘Professional settings’ chapter.
You can program this RC in the same way as the guest RC.
2.1.4.4 How to setup the Easy RC
The RC can be used in both RC5 and RC6 mode, meaning that it can be used for all TV’s. By default the
RC is in RC6 mode (for 301x/501x/701x TV’s). You can change the RC to RC5 mode (for 28x9 TV’s).
 You can change the RC to RC5 mode by pressing 5 seconds “Home” and “Volume up” at the
same time.

Philips HFL4014 Series Specifications

General

Brand	Philips
Model	HFL4014 Series
Category	TV
Language	English