o Navigate to the [Source] menu
o You will see below items:
o [Automatic NTP/Channels]: When
selected, the clock extraction is
performed from a NTP Server or Live
Channels (RF & IP). The NTP has higher
priority than Channels
o [Automatic Channels]: Date and time
is received via channels data (can be
both RF or IP depending on the
installed channels)
o [Automatic NTP]: Date and time is
received via the network
o [Manual]: Date and time is set
manually but will not be
remembered after a power
cycle. This option can be used
in combination with JAPIT or
SerialXpress to set the clock on startup
via commands
o Navigate to the [Source Channel] menu
o You will see a list of installed channels,
one item will be highlighted, this is the
current selected channel where the TV
will obtain the clock from
To Next Page
Loading...
Need help?
General