13
Disposal
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused. For recycling information, please
contact your local waste management facilities or visit www.recycle.philips.com
Troubleshooting
This chapter summarizes the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, visit
www.philips.com/support or in the U.S. or Canada only, call 1-866-309-8817 for
assistance.
Problem Cause Solution
The indicators do not
light up.
The power plug is not
connected correctly.
Check whether the power plug is
plugged correctly and the outlet is
working properly.
After pressing the
On/o button the
appliance sounds but
does not work.
The mixing chamber,
the shaping disc, or the
front panel is assem-
bled incorrectly.
Make sure you follow the user
manual to assemble all parts
correctly.
The safety switch is
triggered and the
appliance suddenly
stopped or suddenly
restarts during the
processing.
The front panel knob is
loose.
Make sure the front panel is securely
assembled.
Excessive ingredients in
the pasta maker.
The maximum amount of our used
for each batch is 600g. If more than
600g is added, reduce the amount
of our before next batch.
During processing,
the appliance stops
working when you
open the lid.
For safety reasons,
the appliance always
stops working when
the lid is opened during
processing.
If you need to resume the previous
operation, close the lid properly, and
press the Start/pause button.
During processing,
the appliance stops.
There is no alarm
sound or ashes.
The pasta maker has
overheated due to long
continuous working
time.
Disconnect from the power source,
and allow the pasta maker to cool
down. To better protect the lifetime
of the appliance, the continuous
working time should be less than 45
minutes. You can restart using the
appliance after 15 minutes of rest.
When weighing the
our, the weight
shown on the screen
changes all the time.
You are touching the
appliance or the power
cord.
When the appliance is weighing the
our, do not touch the appliance or
the power cord.
Small amount of
water is leaking out
from the appliance.
Water is added before
the program starts.
Follow the user manual instructions
to add water right after the program
starts.
To Next Page
Loading...
