Philips HSB2313/12 - Set Clock; Entering Clock Setting Mode; Setting Hour and Minute; Enable Easylink

17
1 Press for over 3 seconds.
The backlight on the display panel »
turns off.
The blue Eco Power indicator lights up.»
Set clock
1
In the standby mode, press and hold
CLOCK to enter the clock setting mode.
» Clock is displayed and the hour digits
begin to blink.
2 Press + VOL - to set the hour.
3 Press CLOCK to confi rm
The minute digits begin to blink.»
4 Press + VOL - to set the minute.
5 Press CLOCK to confi rm the clock setting.
Enable Easylink
EasyLink uses the HDMI CEC (Consumer
Electronics Control) industry standard protocol
to share functionality with all HDMI CEC
compliant devices over HDMI. It enables the
connected devices to control each other with a
single remote control.
Note
EasyLink (HDMI CEC) is only applicable with certain •
criteria. Terms and conditions may vary by product.
Consult your product dealer for information.
Philips does not guarantee 100% interoperability with
•
all HDMI CEC devices.
1 Press SETUP for over 3 seconds.
‘Easylink On’ is displayed.»
To disable Easylink, press and hold »
SETUP until “Easylink Off’ is displayed.
English
EN