EN 8
HTS33003.
Dismantling Instructions & Service Positions
D
Figure 3-4
C
E
3.2 Dismantling of the Tuner Module,
MONO Board, Front Board, PSU Module
1) Loosen 1 screw A (see Figure 3-3) to remove the Tuner
Module (pos 1040).
2) Loosen 9 screws B (see Figure 3-3) and 4 screws
(see Figure 3-4) to remove MONO Board.
3) Release 4 snap hooks to remove Front Board.
- 1 snap hook each on the left & right side (pos 161).
- 2 snap hooks on the bottom side (pos 161).
4) Loosen 4 screws E (see Figure 3-4) to remove the
PSU Module.
3. Dismantling Instructions
3.1 Dismantling of the DVD Loader
1) The tray can be manually open by inserting a minus
screw drive and push the lever in the direction as shown
in Figure 3-1 to unlock the tray before sliding it out.
Figure 3-1
2) Slide out the tray and remove the Cover Tray (pos 110)
as shown in Figure 3-2.
Figure 3-2
3) Loosen 5 screws to remove the Front Top.(pos 240)
- 1 screw each on the left & right side (pos 272)
- 3 screws behind
4) Loosen 4 screws C (see Figure 3-4) to remove the DVD
Loader.
B B
B
A
Figure 3-3
To Next Page
