37
Update software via USB
1 Go to the www.philips.com/support to
check the latest software version available
for this Home Theatre System.
2 Create a folder named ‘UPG’ in the root
of a USB fl ash drive.
3 Download the software onto the ‘UPG’
folder of the USB fl ash drive.
4 Unzip the downloaded software in the
‘UPG’ folder.
5 Insert the USB fl ash drive to this Home
Theatre System.
6 At Home menu, select [Settings]
> [Advanced Setup] > [Software
Download] > [USB].
7 Follow the instructions on the TV to
confi rm update operation.
Once software update is complete, »
this Home Theatre System turns off to
standby automatically.
8 Disconnect the power cord for a few
seconds and connect again to reboot the
Home Theatre System.
Note
Do not turn off the power or remove the USB •
when software updating is in progress as it
may damage the Home Theatre System.
8 Update software
To check for new updates, compare the current
software version of your home theatre with
the latest software version (if available) on the
Philips website.
1 Press .
2 Select [Settings], then press OK.
3 Select [Advanced Setup] > [Version
Info.], then press OK.
Update software via network
1 Prepare the network connection, see
chapter ‘Getting Started’ > ‘Set up
network’ for detailed information.
2 At Home menu, select [Settings]
> [Advanced Setup] > [Software
Download] > [Network].
3 Follow the instructions on the TV to
confi rm update operation.
Once software update is complete, »
this Home Theatre System turns off to
standby automatically.
4 Disconnect the power cord for a few
seconds and connect again to reboot the
Home Theatre System.
English
EN
To Next Page
Loading...
