Philips LCD TV - Use a CAM

EN 46
• [Amplifier]: Streams audio through the
connected HDMI-CEC device. If system
audio mode is not enabled on the
device, audio will continue to stream
from TV speakers if [EasyLink] was
selected. If [EasyLink autostart] was
enabled, the TV prompts the
connected device to switch to system
audio mode.
Use HDMI ARC
The HDMI 1 connector is HDMI Audio Return Channel (ARC) compliant. Use it to output digital
audio to a HDMI Home Theatre System.
HDMI ARC allows you to use Philips
EasyLink to output TV audio directly to a
connected audio device, without the need
for an additional digital audio cable.
Be sure that the device is HDMI-CEC and
ARC compliant, and that the TV is
connected to the device using a HDMI cable
attached to HDMI ARC connectors.
Enable or disable HDMI ARC
Note: Enabling HDMI ARC automatically
adds the device to the home menu.
1. Press
.
2. Select [Setup] > [TV settings] >
[EasyLink] > [HDMI 1 - ARC] > [On] or
[Off].
3. Press OK to activate.
Use a CAM
Insert and activate a CAM
*Available on certain models only.
Caution: Be sure to follow the instructions
described below. Wrong insertion of a
Conditional Access Module (CAM) may
damage both the CAM and your TV.
Notes:
• This TV supports CI as well as CI+. CI+
allows service providers to offer
premium HD digital programs with a
high level of copy protection.
• Refer to the documentation from your
service operator on how to insert a
smart card into the Conditional Access
Module.