Philips LX7100SA - Getting Started; Remote Control Battery Installation; Setting the System Clock

18
English
3139 115 22741
Getting Started
Step 1: Inserting batteries
into the remote
control
1
3
2
1 Open the battery compartment.
2 Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3 Close the cover.
Using the remote control to
operate the system
1 Aim the remote
control directly at the
remote sensor (iR) on
the front panel.
2 Select the source you
wish to control by
pressing one of the
source select buttons
on the remote control
(for example TV/AV,
TUNER).
3 Then select the desired
function (for example
2; ,
S, T).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00"
for example).
CLOCK/TIMER
PROG
1
2
3
4
12:00 AM
00:00
SEARCH/PREV
SEARCH/PREV
13:38
13:38
CLOCK/TIMER
1 In standby mode, press CLOCK/TIMER
once.
➜ "12:00 AM" or "00:00" will flash.
2 Press PROG to change between 12-hour
and 24-hour clock mode.
3 Press S / T to set the minutes and
hours. To increase the speed, hold down
S or T.
➜ The changes in minutes will roll over
to the hours.
4 Press CLOCK/TIMER again to store
the setting.
➜ The clock will start working.
To view the clock time in any active
mode
● Press CLOCK/TIMER.
➜ The clock will display for a few seconds.
Helpful Hints:
– If the DVD system is disconnected from
the power supply, it will erase the clock
setting.
– If you do not press any buttons within 90
seconds, the system will exit clock setting
mode.
SOUND
VOLUME
SURROUND
iR
SENSOR
buttons on
top panel
DVD system’s
display panel
001-045-LX71-22-Eng 8/07/2003, 11:26 AM18