EN 9
2. Press and hold [SCAN/OK]for more than 2
seconds.
- The product scans and stores all DAB+ radio
stations automatically.
Select a DAB+ radio station
After DAB+ radio stations are scanned and stored,
press / to select a DAB+ station.
Store DAB+ radio stations manually
1. Press DAB/FM to select a DAB+ radio station.
2. Press [PRESET] to activate program mode.
3. Press / to allocate a number from 1–20 to
this radio station, and then press [PRESET] to
4. Repeat steps 1-3 to program more stations.
To select a preset DAB+ radio station: In DAB+
mode, press / .
DAB+ menu Selection and Information Display
1. In DAB+ mode, press MENU / INFO to access
DAB+ menu.
2. Press / to toggle the menu options.
[SCAN]: Scan and store all available DAB+ radio
stations.
[MANUAL]: Tune to a DAB+ station manually.
[PRUNE]: Remove invalid stations from the station
list.
[SYSTEM]: Adjust system settings.
3 .To select an option, press SCAN / OK
4. If a sub-option is available, repeat steps 2-3.
• To exit the menu, press MENU / INFO again.
Under [SYSTEM] (system) menu
• [RESET] (reset): reset all settings to factory default.
• [SW VER] (software version): show the software
version of this product.
Display DAB+ information
While listening to DAB+ radio, press MENU / INFO
repeatedly to display various information (if
available), such as frequency, signal strength,
time, etc.
Listen to FM radio
Tune to an FM radio station
1. Press DAB/FM to select a FM radio station
2. Press and hold / or more than 2 seconds.
- The radio tunes to a station with strong reception
automatically.
3. Repeat step 2 to tune to more stations.
To tune to a weak station: Press / repeatedly until
Store FM radio stations Automatically
Note
• You can store a maximum of 20 FM radio stations.
1. Press DAB/FM repeatedly to select FM source.
2. Press and hold SCAN/OK for more than 2 seconds.
- All available stations are programmed in the order of
waveband reception strength.
automatically.
Store FM radio stations manually
1. Tune to an FM radio station.
2.Press SCAN/OK to activate program mode.
- [P01] is displayed.
3. Press / to allocate a number from 1–20 to this
radio station, and then press SCAN/OK
4. Repeat steps 1-3 to program more stations.
Note
• To overwrite a programmed station, store another station
in its place.
Select a preset FM radio station
In FM mode, press / to select a preset number.
• While listening to FM radio, you may press SCAN/OK to
toggle stereo and mono sound.
Display RDS information
RDS (Radio Data System) is a service that allows FM
stations to show additional information.
1. Tune to an FM radio station.
2. Press MENU/INFO repeatedly to display various RDS
information (if available), such as station name, program
type, time, etc.
To Next Page
Loading...
