Philips M550 - Register additional handsets; Unregister handsets; Restore default settings

28 EN
Register additional handsets
You can register additional handsets to the base
station. The base station can register up to 3
handsets.
1 Press MENU/OK on the handset.
2 Select [Services] > [Register].
3 Press and hold on the base station for 5
seconds, then press MENU/OK to conrm.
4 Enter the system PIN/passcode. Press
REDIAL/C to make corrections. Press
MENU/OK to conrm the PIN/passcode.
Note
• For models with an answering machine, you hear a
conrmation beep.
» Registration is complete in less than 2
minutes. The base automatically assigns
a handset number to the handset.
Note
• If the PIN/passcode is incorrect or no base is found
within a certain period, your handset displays a
notication message. Repeat the above procedure if
registration fails.
Note
• The preset PIN/passcode is 0000. No change can be
made on it.
Unregister the handsets
1 If two handsets share the same base
station, you can unregister a handset with
another handset.
2 Press MENU/OK.
3 Select [Services] > [Unregister], then
press MENU/OK to conrm.
4 Enter the system PIN/passcode. (The
preset PIN/passcode is 0000). Press
REDIAL/C to remove the number.
5 Select the handset number to be
unregistered.
6 Press MENU/OK to conrm.
» The handset is unregistered.
Tip
• The handset number displays beside the handset name
in standby mode.
Restore default settings
You can reset your phone settings to the
original factory settings.
1 Press MENU/OK.
2 Select [Services] > [Reset], then press
MENU/OK to conrm.
» The handset displays a conrmation
request.
3 Press MENU/OK to conrm.
» All settings except the phonebook are
reset.