Philips MC-77 - Basic Functions: Plug and Play Installation; Automatic Radio Station Scanning

14
English
3103 306 18522
Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1 When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2 Press PLAYÉ (ÉÅ ) on the system to start
installation.
➜ "INSTALL" is displayed and followed by
"TUNER" and "AUTO".
➜ PROGRAM starts flashing.
➜ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1 In standby or demonstration mode, press and
hold PLAYÉ(ÉÅ ) on the system until
"AUTO INSTALL - PRESS PLAY" is
displayed.
2 Press PLAYÉ (ÉÅ ) again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press Çon the system.
➜ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialize the system.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" is displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.
-
-+
-
OPEN
STANDBY
-
ON
iR
VOL
AUX/ CDR
PROG
PRESET
TAP E
SEARCH/ TUNE
TUNER
DEMO STOPPAUSE
PREV
NEXT
REC
STOP
PLAY
BASS TREBLE
NEWS
-+
CD 1•2•3
ECO
POWER
pg 001-032/MC77/37-Eng 4/16/02, 7:19 PM14