Philips MC-77 - Random Play; Programming the Disc Tracks; Erasing the Program

20
English
3103 306 18522
2 To resume normal playback, press REPEAT
until "OFF" is displayed.
➜ REPEAT is shown, except for REPEAT OFF
mode.
Random play
1 Press SHUFFLE on the remote control.
➜ SHUFFLE is shown and "SHUFFLE" is
displayed.
➜ All the available discs or programmed tracks
(if programme is active) will be played in random
order.
2 To resume normal playback, press SHUFFLE
again.
➜ SHUFFLE disappears.
Notes:
– Selecting SHUFFLE during repeat playback will
cancel all repeat modes.
– Pressing the CD OPEN•CLOSE button will cancel
all repeat and shuffling modes.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1 Load the desired discs on the disc trays (refer to
“Loading Disc”).
2 Press PROG to start programming.
➜ PROGRAM starts flashing.
3 Press CD 1•2•3 or CD DIRECT 1/2/3 button
to select a disc.
4 Press í or ë repeatedly to select the desired
track.
5 Press PROG to store the track.
● Repeat steps 3–5 to store other discs and tracks.
6 To end programming, press Ç once.
➜ PROGRAM stays and the program mode
remains active.
➜ The total number of tracks programmed and
the total playing time are displayed.
7 Press PLAYÉ (ÉÅ ) to start program
playback.
➜ "PLAY PROGRAM" is displayed.
CD Operation
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to program more than 40 tracks,
"PROGRAM FULL" is displayed.
– If you press any of the CD DIRECT 1/2/3
buttons on the remote control, the system will play
the selected disc or track, and the stored program
will be ignored temporarily. The PROGRAM symbol
also will disappear temporarily from the display. It
will reappear when playback of the selected disc
ends.
– During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
To review the program
● Stop playback and press í or ë repeatedly.
● To exit review mode, press Ç.
Erasing the program
● Press Ç once when playback is stopped or
twice during playback.
➜ PROGRAM disappears and "PROGRAM
CLEARED" is displayed.
Note:
– The program will be erased when the system is
disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to “Tap e
Operation/Recording”.
pg 001-032/MC77/37-Eng 4/16/02, 7:19 PM20