19
English
3103 306 18522
CD Operation
Playing discs
a disc is loaded in the disc tray
the current selected disc tray is empty
the current selected disc tray is loaded
the disc tray is currently playing
To play all discs on the disc tray
● Press PLAYÉ (ÉÅ ).
➜ All the available discs will play once, then stop.
➜ During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To play the selected disc only
● Press one of the CD DIRECT 1/2/3 buttons
on the remote control.
➜ The selected disc will play once, then stop.
To interrupt playback
● Press PAUSEÅ (ÉÅ ).
➜ The current track time flashing.
● To resume playback, press PLAYÉ (ÉÅ )
again.
To stop playback
● Press Ç.
Selecting a desired track/passage
To search for a particular passage during
playback
● Press and hold à or á and release it when
the desired passage is located.
➜ During searching, the volume will be reduced.
To select a desired track
● Press í or ë repeatedly until the desired
track is displayed.
● If playback is stopped, press PLAYÉ (ÉÅ ) to
start playback.
Note:
– In Shuffle mode, pressing
í
will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
● Press í once.
To resume playback from the last
selected track
● In CD stop mode, press CD RESUME on the
remote control to start playback again from
where you have stopped.
Notes:
– Resume will not be available if you have
changed the disc, opened the disc tray or
disconnected the system power supply.
– Select CD RESUME in any other source mode
will only able to resume the last selected CD active
mode (for example, CD stop or playback).
Replacing discs during playback
You are able to replace or load in disc into the
other two disc trays without interrupting current
playback.
● While playback, press the CD OPEN•CLOSE
button of the inactive disc trays (refer to
“Loading Disc”).
● If you press CD OPEN•CLOSE button of the
active disc tray, the disc will stop playing and the
disc tray will slide out.
➜ Once the disc tray is opened, it will be
deselected.
Repeat and Shuffle
You can select and change the various play
modes before or during playback.
Repeat play
1 Press REPEAT on the remote control
repeatedly to select :
➜ "TRACK" – to repeat playback of the
current track.
➜ "DISC" – to repeat playback of the current
disc.
➜ "ALL DISC" or "PROGRAM" – to repeat
playback of all available discs or programmed
tracks.
pg 001-032/MC77/37-Eng 4/16/02, 7:19 PM19
To Next Page
Loading...
