22
English
3139 115 20972
6 Repeat steps 3–5 to store other discs and
tracks.
7 To end programming, press Ç once .
➜ PROG stays and the programme mode
remains active.
➜ The total number of tracks programmed and
the total playing time are displayed.
8 To start programme play, pressÉÅ .
➜ "PLAY PROGRAM" is displayed.
Notes:
– If the total programmed playing time is more
than 320 minutes, "--:--" is displayed.
– If you attempt to programme more than 99
tracks, "PROGRAM FULL" is displayed.
– In programme mode, pressing the CD DIRECT
1/2/3 buttons on the remote control will play the
selected disc and the stored programme will be
ignored temporarily. The programme will resume
when playback of the selected disc ends.
– During programming, if no key is pressed within
20 seconds, the system will exit the Programme
mode automatically.
To review the programme
● Stop playback and adjust JOG CONTROL (or
pressí or ë on the remote control).
● To exit review mode, press Ç.
Changing the programme
1 Press PROG.
2 Press à or á to move to the track number
you want to change.
3 To remove the track from the programme;
Refer to ”Erasing the programme”.
To insert a new track;
Adjust JOG CONTROL to select a new track
and press YES to confirm.
➜ The new track will be inserted in front of the
selected track.
Erasing the programme
To erase a track
1 Stop playback and press CD 1•2•3 or CDR to
select a disc.
2 Press PROG.
3 Press à or á to select a track number.
4 Press NO to erase the selected track from the
programme.
➜ "CLEARED" is displayed.
➜ The following programme tracks’ numbers
are decreased by one.
To erase the entire programme
1 Stop playback and press NO.
➜ "CLEAR PROG?" is displayed.
2 Press YES to erase the entire programme.
➜ PROG disappears and "PROG CLEARED" is
displayed.
Note:
– The programme will be erased when the system
switched to standby mode, disconnected from the
power supply or when the disc tray is opened.
CD Changer/Recorder Operations
pg 001-038/MC90/22-Eng 1/29/02, 6:37 PM22
To Next Page
Loading...
