English
15
Preparation
Setting the clock
After connecting MCB275 to the power supply,
set the clock first.
1 Press and hold STANDBY-ON/ ECO
POWER to switch the set to Standby mode.
➜ The display shows the set time.
2 In the standby mode, press and hold CLOCK
on the remote control.
➜ The hours digits start flashing.
3 Press 4 / ¢ (or ¡ / ™ on the remote
control) repeatedly to set the hours.
4 Press CLOCK to confirm.
➜ The minute digits start flashing.
5 Press 4 / ¢ (or ¡ / ™ on the remote
control) repeatedly to set the minutes.
6 Press CLOCK to confirm.
– To exit without storing the clock setting press
STOP 9.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
–To set the clock automatically by using a time
signal which is broadcast together with the RDS
signal see chapter RDS: Automatic clock
setting via RDS.
Before using the remote control
1 Pull out the plastic protective sheet.
2 Select the source you wish to control by
pressing one of the source select keys on the
remote control (for example DISC, FM).
3 Then select the desired function (for example
ÉÅ , à , á).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote
control
1 Press the slot on the battery compartment.
2 Pull out the battery compartment.
3 Replace a new battery and fully insert the
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
P001-P030_MCB275_05_Eng 2007.6.13, 10:2815
To Next Page
Loading...
