9
English
EN
Connect power
Caution
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
Before connecting the AC cord, make sure that you
have completed all other connections.
Note
The type plate is located on the rear of the main unit.
1 Connect the power cord to the jack
on the main unit.
Connect the power plug to the wall outlet.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
To insert the remote control battery:
1 Open the battery compartment.
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
Close the battery compartment.
Note
If you are not going to use the remote control for a
long time, remove the batteries.
Do not use old and new or different types of batteries
in combination.
Batteries contain chemical substances, so they should
be disposed of properly.
Turn on
Press .
» The unit switches to the last selected
source.
When the unit is turned on, press to switch
the unit to standby.
MCD1065_51_UM_V1.0.indb 9 2012-2-27 17:43:12
To Next Page
Loading...
