10 EN
In standby, press and hold over
three seconds to switch from normal
versa.
»
In normal standby, the clock (if set)
appears on the display panel.
»
the display panel turns off.
Note
If no source is played within 15 minutes, the unit
switches to standby mode.
If no operation is performed within 15 minutes in
mode.
Press to switch the unit to the last source when it
was turned off.
In the standby mode, press .
» (welcome
to Philips) scrolls on the display.
» (demo on) scrolls on
the display.
» The feature names are displayed one
by one.
To exit the feature demonstration,
press
again.
» (demo off) scrolls on
the display.
Note
You can set the clock in standby mode only.
1 Press to switch the unit to standby.
Make sure that --:-- (or clock) is displayed.
Press and hold
to
activate the clock setting mode.
»
(clock set) is displayed.
»
The 12 hour or 24 hour format is
displayed.
Press / or
to select 12 hour
or 24 hour format.
5 Press
.
»
The hour digits begin to blink.
6 Press / or
to set the hour.
Press
.
»
The minute digits begin to blink.
8 Press / or to set the minute.
Press
Note
To exit clock setting mode without storing, press .
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to the power supply.
»
(press
to start
automatic installation, or press
to
cancel) is displayed.
Press on the main unit to start
installation.
» The unit automatically stores radio
» When all the available radio stations
is broadcast automatically.
MCD1065_51_UM_V1.0.indb 10 2012-2-27 17:43:13
To Next Page
Loading...
