Philips MCD122 - Decoder Board Circuit Diagram (Part 2)

21
Program radio stations
manually
Note
 You can program a maximum of 20 preset radio
stations.
1 Tune to a radio station.
2 Press ANGLE/PROG to activate
programming.
3 Press / to allocate a number from
1 to 20 to this radio station, then press
ANGLE/PROG
» 
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Note
 To overwrite a programmed station, store another
station in its place.
Tune to a preset radio station
1
Press / to select a preset number
that you want.
Tip
 You can also use the numerical keypad to select a
preset station directly.
7 Tune to FM
radio stations
1 Ensure that you have connected and fully
extended the supplied FM antenna.
2 Press TUNER.
3 Press and hold / .
4 
change, release the button.
» The FM tuner tunes to a station with
strong reception automatically.
5 Repeat steps 3-4 to tune to more stations.
To tune to a weak station:
Press
/ 
reception.
Program radio stations
automatically
Note
 You can program a maximum of 20 preset radio
stations.
1 Press / to select a preset number to
start programing.
2 Press and hold ANGLE/PROG for
2 seconds to activate automatic
programming.
» [AUTO]
» All available stations are programmed
in the order of waveband reception
strength.
» The last programed radio station is
broadcast automatically.
English
EN