Connections
IMPORTANT!
–To set the VIDEO OUT (put) to ‘Cr Cb
Y’, (see Setting video preference).
Using component Video In jack (Cr Cb
Y)
Use the component video cables (red/blue/
green) to connect the system’s Cr Cb Y jacks to
the corresponding Component video input jacks
on the TV set.
Pr/Cr
Pb/Cb
Y
S-VIDEO OUTVIDEO OUT
DIGITAL OUT
AUX in
RL
LINE OUT
SUBWOOFER OUT
COMPONENT VIDEO OUT
AM
aerial
IMPORTANT!
– If the picture is distorted, check the
Video Output setting. Make sure it is set
to ‘S-Video’. (See Setting video
preference).
Using S-Video In jack
Use the S-Video cable (not supplied) to connect
the system’s S-VIDEO OUT jack to the S-
Video input jack (or labeled as Y/C or S-VHS) on
the TV 0
Pr/Cr
Pb/Cb
Y
S-VIDEO OUTVIDEO OUT
DIGITAL OUT
AUX i n
RL
LINE OUT
SUBWOOFER OUT
COMPONENT VIDEO OUT
AM
aerial
Connections
Step 2: Connecting speakers
speaker
(right)
speaker
(left)
-
L
+
+
R
-
SUBWOOFER OUT
SPEAKER
Connect the speaker wires to the SPEAKERS
terminals, right speaker to “R” and left speaker to
“L”, coloured (marked) wire to “+” and black
(unmarked) wire to “–”. Fully insert the stripped
portion of the speaker wire into the terminal as
shown.
Notes:
–For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
IMPORTANT!
The type plate is located on the rear of
the system.
To avoid overheating of the system, a
safety circuit has been built in.
Therefore, your system may switch to
Standby mode automatically under
extreme conditions. If this happens, let
the system cool down before reusin
it.
Step 3: Connecting TV set
IMPORTANT!
–You only need to make one video
connection from the following options,
according to the capabilities of your TV
system.
– Component Video connection
provides higher picture quality. These
options must be available on your TV set.
– Connect the system directly to the TV
set.
Using Video In jack (CVBS)
Use the composite video cable (yellow) to
connect the system’s VIDEO OUT jack to the
video input jack (or labeled as A/V In, Video In,
Composite or Baseband) on the TV set.
Speakers
Front Left (L)
Front Right (R)
Black
Black
Grey
Grey
–––-
+
Pr/Cr
Pb/Cb
Y
S-VIDEO OUTVIDEO OUT
DIGITAL OUT
AUX i n
RL
LINE OUT
SUBWOOFER OUT
COMPONENT VIDEO OUT
AM
aerial
To Next Page
Loading...
