Philips MCD280/21M - System Connections; Subwoofer and Digital Output Setup; Power Cord Connection

3 - 4
Connections
Step 5: Connecting Digital out
DIGITAL IN
Pr/Cr
Pb/Cb
Y
S-VIDEO OUTVIDEO OUT
DIGITAL OUT
AUX in
RL
LINE OUT
COMPONENT VIDEO OUT
AM aerial
IMPORTANT! To select ALL or PCM 48 KHz for Digital Out, please see Setting Digital Out. Digital out selecion enables you to specify the type of digital output suitable for our amplifier or receiver. Select ALL if you have connected the digital output to a multifunctional decoder receiver. Select PCM 48K if the external component is incapable of processing 96KHz digital signal input, and then convert the standard signal with the sampling rate of 48KHz.
Step 6: Connecting the power
cord
~ AC MAINS
AUDIO
OUT
Pr/Cr
Pb/Cb Y
S-VIDEO
IN
VIDEO IN
COMPONENT
VIDEO IN
Power Outlet
- L + + R -
SPEAKER
IMPORTANT!
Never make or change any connection with the power switched on. After every is connected properly, plug in the AC power cord to the power outlet.
CONNECTION AND CONTROLS
Connections
IMPORTANT! – If your TV set only has a single Antenna In jack (or labeled as 75 ohm or RF In), you will need a RF modulator in order to view the DVD playback via TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.
Using an accessory RF modulator
Use the composite cable (yellow) to connect the system’s CVBS jack to the video input jack on
the RF modulator.
Use the RF coaxial cable (not supplied) to connect the RF modulator to your TV’s RF
j
ack.
AUDIO IN
R L
VIDEO
IN
TO TVANT IN
CH3 CH4
RF coaxial cable to TV
Back of RF Modulator
(example only)
Antenna or
Cable TV signal
Pr/Cr
Pb/Cb
Y
S-VIDEO OUTVIDEO OUT
DIGITAL OUT
COMPONENT VIDEO OUT
Step 4: Connecting the
subwoofer (not
supplied
)
speaker
(right)
speaker
(left)
Subwoofer
4
- L + + R -
SUBWOOFER OUT
SPEAKER
IMPORTANT! Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short circuit. Do not connect speakers with an impedance lower than that of the speakers supplied. Place the subwoofer on the floor near the TV. Connect the subwoofer to the SUBWOOFER OUT jack on the DVD micro system. Connect the power cable for the subwoofer.
R