Philips MCM103 - 8 Listen to Radio; Tuning and Preset Radio Stations

15
9 Other features
Set the alarm timer
This unit can be used as an alarm clock. The
DISC, TUNER or USB is activated to play at a
preset time.
1 Ensure that you have set the clock
correctly.
2 Press and hold TIMER.
3 Press DISC , TUN or USB to select a
source.
4 Press TIMERWRFRQÀUP
The hour digits are displayed and begin »
to blink.
5 Press / to set the hour.
6 Press TIMERWRFRQÀUP
The minute digits are displayed and »
begin to blink.
7 Press / to set the minute.
8 Press TIMERWRFRQÀUP
The timer is set and activated.»
Activate and deactivate alarm timer
1 Press TIMER ON/OFF repeatedly to
activate or deactivate timer.
If timer is activated, the display shows »
.
If timer is deactivated, »
disappears on
the display.
Note
Alarm timer is not available in MP3 LINK 
mode.
If DISC/USB source is selected and the

track cannot be played, tuner is activated
automatically.
Program radio stations
manually
Note
You can program a maximum of 20 preset 
radio stations.
1 Tune to a radio station.
2 Press PROG to activate program mode.
[PROG] (program) blinks on the display.»
3 Press ALB/PRESET+/- to allocate a
number (1 to 20) to this radio station,
then press PROGWRFRQÀUP
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Note
To overwrite a programmed station, store 
another station in its place.
Select a preset radio station
1
Press ALB/PRESET+/- to select a preset
number.
Tip
)0DQWHQQDLVÀ[HGWRWKHPDLQXQLW
Position the antenna as far as possible from 
TV, VCR or other radiation source.
For optimal reception, fully extend and adjust

the position of the antenna.
English
EN