Philips MCM103 - 4 Get Started; Power and Remote Control Setup

10
4 Get started
Caution
Use of controls or adjustments or performance 
of procedures other than herein may result in
hazardous radiation exposure or other unsafe
operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from 
KHDWVXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHV
LQÀUH
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Connect power
Caution
Risk of product damage! Ensure that the 
power supply voltage corresponds to the
voltage printed on the back or the underside
of the unit.
Before connecting the AC power cord, ensure

you have completed all other connections.
Note
The type plate is located on the rear of the 
main unit.
The voltage selector is at the bottom of the

main unit
1 Switch the voltage selector to the local
power line voltage.
2 Connect the AC power cord to the AC
MAINS~ jack on the main unit and to the
wall socket.
EN