EasyManua.ls Logo

Philips MCM103 - Set the Sleep Timer; Listen to an External Device; 10 Product Information

Philips MCM103
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
10 Product
information
Note
Product information is subject to change
without prior notice.
6SHFLÀFDWLRQV
$PSOLÀHU
Rated Output Power 2X5W RMS
Frequency Response 60 - 16kHz, ±3dB
Signal to Noise Ratio >65dB
Aux Input 0.5 V RMS 20kohm
Disc
Laser Type Semiconductor
Disc Diameter 12cm/8cm
Support Disc CD-DA, CD-R,
CD-RW, MP3-CD,
WMA-CD
Audio DAC 24Bits / 44.1kHz
Total Harmonic
Distortion <1%
Frequency Response 60Hz -16kHz (44.1kHz)
S/N Ratio >65dBA
Tuner
Tuning Range FM: 87.5 - 108 MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N
Ratio
< 22 dBf
Search Selectivity < 36 dBu
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 When the unit is turned on, press SLEEP
repeatedly to select a set period of time
(in minutes).
When sleep timer is activated, the »
display shows
.
To deactivate sleep timer
1 Press SLEEP repeatedly until [OFF] is
displayed.
When sleep timer is deactivated, »
disappears on the display.
Listen to an external device
You can listen to an MP3 player through this unit.
1 Press MP3 LINK to select MP3 LINK
source.
2 Connect the supplied MP3 link cable to:
 MP3 LINK jack (3.5 mm) on the unit
the headphone jack on an external 
device
3 Start to play the device (see the device
user manual).
EN

Other manuals for Philips MCM103

Related product manuals