Philips MCP9350i - Page 36

EN 36 11. MCP9350i
Hardware Tests
16. Click on back to return to the Which Tuners Do You Want to Confiure? screen. Select NVIDIA NVTV Dual Tuner Card Tuner 2.
17. Repeat the previous S-Video and Composite video checks for Tuner 2.
18. Click on ‘Cancel’ to stop this TV signal installation, without saving the new settings.
11.25.3. Fail Procedure
- Replace the PCI riser card. See paragraph 12.7.1.
- Replace the TV tuner card. See paragraph 12.7.1.
- Replace the motherboard. See paragraph 12.16.9.
11.26. VFD Display and Buttons
11.26.1. Required Equipment
Audio CD
11.26.2. Test Procedure
1.
Insert an Audio CD into the ODD.
2.
Use the transport control buttons located below the VFD display to navigate the CD. Check that each button operates correctly.
3. Check that the VFD display is functioning.
11.26.3. Fail Procedure
- Replace the VFD_USB cable.
- Replace the VFD board. See paragraph 12.13.
- Replace the motherboard. See paragraph 12.16.9.
11.27. Remote Control and Infrared Receiver
11.27.1. Required Equipment
•
Use the remote control that was returned with the Media Center.
• If no remote control was returned, use your own.
11.27.2. Test Procedure
Use the volume up and down buttons on the remote control to test correct operation of the infrared receiver and remote.
11.27.3. Fail Procedure
- Replace the remote control batteries.
- Replace the remote control.
- Replace the VFD_USB cable.
- Replace the VFD board. See paragraph 12.13.
- Replace the motherboard. See paragraph 12.16.9.