Philips OTT2000 - Getting Started; Power and Remote Control Setup

8 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect power
Connect the AC power cord to the AC
MAIN~ socket and then to the wall outlet.
Prepare remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
For rst-time use:
1 Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert one CR2032 battery with correct
polarity(+/-)asindicated.
3 Close the battery compartment.
Note
•
Before pressing any function button on the remote
control,rstselectthesourcewiththeremotecontrol
and not the main unit.
• If the the remote control will not be used for an
extended period of time, remove the battery.
Turn on
Press .
» The product switches to the last
selected source.
• To switch the product to standby
mode, press
again.