Philips OTT2000 - FM Radio Operations

14 EN
5 Listen to FM
radio stations
1 Turn the SOURCE knob to select FM
source.
2 Search for radio stations automatically or
manually.
Note
•
For optimal reception, fully extend the antenna and
adjust its position.
• You can store a maximum of 20 FM radio stations.
Search for a radio station
automatically
1
Press and hold / for more than 2
seconds.
» The radio automatically tunes to a
station with strong reception.
2 Repeat step 1 to tune to more stations.
» When a radio station with a strong
signal is detected, the search stops and
the radio station is broadcast.
Program radio stations
automatically
1
Press CLOCK/PROG for more than 2
seconds to activate automatic program
mode.
» All available stations are programmed
in the order of waveband reception
strength.
» Therstprogrammedradiostationis
broadcast automatically.
2 Press / to select preset radio stations.
Program radio stations
manually
1
Press / to tune to a radio station.
2 Press CLOCK/PROG to activate the
programming.
3 Press / to allocate a number to this
radio station.
4 Press CLOCK/PROGtoconrm.
» The radio station is stored with the
selected sequence number.
5 Repeat steps 1-4 to program more radio
stations.
Note
•
If a radio station is stored over the sequence number
of a previously saved station, the earlier station will be
overwritten.
Select stereo/mono broadcast
To improve the reception of stations with weak
signals, monaural sound should be selected.
• In tuner source, press FM/ST/MO to select
a setting:
• [STEREO]: stereo broadcast.
• [MONO]: monaural broadcast.