What to do if my Philips Projector doesn't work with my laptop?
If the Philips Projector does not work when connecting to a notebook PC, check that the HDMI cable is correctly plugged in and ensure that the notebook PC has been switched to projector display.
Why doesn't screen mirroring work on my Philips PicoPix PPX5110 Projector with Android?
If screen mirroring doesn't work with your Android device on the Philips Projector, your device must support Miracast. Not all Android phones support this function. Please refer to the user manual of your Android phone to check if this function is supported and how it can be enabled.
What to do if my Philips PicoPix PPX5110 Projector won't charge or turn on?
If the Philips Projector does not charge or cannot be switched on, it is likely that the battery is completely empty. In this case, try charging the projector for at least four hours. If charging doesn't resolve the issue, use a small pin and gently push it into the Reset hole.
What to do if my Philips PicoPix PPX5110 won't turn off?
If the Philips Projector cannot be turned off, try using a small pin and gently push it into the Reset hole. If this doesn't work, disconnect the power cable.
How to fix a Philips Projector when the HDMI image doesn't appear?
If the image from the external HDMI device does not appear on your Philips Projector, try the following steps: Disconnect the HDMI cable or switch off the HDMI device, wait three seconds, and then reconnect the HDMI cable or switch on the HDMI device again.
How to turn on or off a Philips PicoPix PPX5110?
To switch your Philips Projector on or off, press and hold the B button for eight seconds.
Why is the sound or picture distorted on my Philips PicoPix PPX5110 Projector when viewing videos?
When viewing videos on your Philips Projector, distorted sound or picture, or sound not synchronous with the picture can occur if the available Wi-Fi bandwidth is insufficient due to multiple Wi-Fi networks operating nearby, or if your smartphone isn't fast enough to compress and send screen data over Wi-Fi. Your smartphone may also maintain parallel connections to your home network and the projector. Disabling temporarily the connection to your home network may help.
Why doesn't USB projection work on my Philips Projector?
If USB projection does not work on your Philips Projector, make sure you are using an iOS smartphone, as it does not function with Android. Also, ensure you have selected iOS mode and that the “Hotspot” function of your iPhone is switched to “On.”
Can you connect a power bank to a Philips Projector?
To connect a power bank to the Philips Projector, connect it to the micro USB port of the projector. The minimum requirement to ensure proper operation is 3 A at 5 V. Do not operate the projector with less than this minimum requirement.
Why is my Philips PicoPix PPX5110 so hot?
It is normal for the Philips Projector to generate moderate heat during operation.
Instructions for safely placing and operating the device in its environment.
Guidelines for power supply usage and battery handling.
How to connect the projector to playback devices using an HDMI cable.
Instructions for connecting audio devices to the projector's audio out socket.
Guide to wirelessly mirroring an iPhone/iPad screen to the projector.
Instructions for screen mirroring an iOS device using a Lightning to USB cable.
General| Resolution | 854 x 480 pixels |
|---|---|
| RS-232 ports | 0 |
| Projection distance | 0.53 - 3.19 m |
| Projection technology | DLP |
| Contrast ratio (typical) | 1000:1 |
| Screen size compatibility | - \ |
| Projector native resolution | WVGA (854x480) |
| Lamps quantity | 1 lamp(s) |
| Service life of light source | 20000 h |
| Focal length range | - mm |
| 3D | No |
| Analog signal format system | Not supported |
| HDMI connector type | Mini |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Wi-Fi | Yes |
| Wi-Fi standards | 802.11b, 802.11g, Wi-Fi 4 (802.11n) |
| Noise level | - dB |
| Mobile operating systems supported | Android, iOS |
| Product type | Short throw projector |
| Product color | Grey, White |
| Market positioning | Portable |
| Power source | AC/Battery |
| Battery capacity | 1900 mAh |
| Battery life (max) | 1 h |
| Power consumption (standby) | - W |
Weight and Dimensions| Width | 98 mm |
|---|---|
| Height | 27.5 mm |
| Weight | 215 g |
To Next Page