The mobile will return to the channel that was selected before the scan function was initiated.
1.5.6.2 SELECTION OF PRIORITY CHANNEL (if enabled)
Select the required channel by using 'Channel UP' button.
Use the 'SCAN' button to initiate scanning.
The channel selected will automatically become the priority channel.
Note: The 'ERROR TONE' will sound if the channel that is selected
is not permitted as a scan channel.
1.5.7 Selective Call Facilities
Selective call is an optional fitting which can allow the mobile radio to respond to, and/or initiate a
signal carrying an identifying number.
A number of different operations are available depending on the system configuration and the
features programmed.
The facilities currently available are indicated below. Please note that some of these may not be
available on your equipment.
1.5.7.1 SEND 1
The Send button causes a programmed identity to be transmitted. This identity is used to identify
the mobile to the base control.
1.5.7.2 SEND 2
Used as Send 1 but provides for a second identity.
1.5.7.3 ALARM
Alarm is a special version of Send. It is used to indicate the presence of an alarm condition or it
can be used as a priority call request. The exact use of this function will depend upon how your
particular radio system has been designed. You should have specific instructions about when this
button is to be used.
Please note that the mobile radio is controlled by the base controller during the
emergency mode.
Alarm may also be activated by a special switch (if fitted),external to the
equipment.
Alarm condition can be reset from base control, or by disconnecting the radio
from the battery.
Section 1 Page 13
To Next Page
Loading...
Need help?
General
