ii) Transmitter Power 1 to 6 watt, 1 to 25 watt, 10 to 40 watt.
(Different printed circuit board assemblies required for
each option).
iii) Frequency Band EO band, A9 band/BO band, Tm band,
UO band, W 1 band, W4 band.
(Different printed circuit board assemblies required for
each band).
iv) Channel Spacing 12.5kHz, 20kHz, 25/30kHz.
(Different printed circuit board assemblies required for
each option).
v) Frequency Stability: +/-5 ppm -10 to +60 Deg C (Better quality crystal).
+/-10 ppm -10 to +60 Deg C (Standard crystal).
+/-5 ppm -30 to +60 Deg C (Extended temp option).
+/-2.5 ppm -10 to +60 Deg C (TXCO).
+/-2.5 ppm -30 to +60 Deg C (TCXO)
+/-10 ppm -30 to +60 Deg C (Extended temp option)
vi) Receiver Mute Adjustable/Preset.
(Additional components required on printed circuit board).
vii) Signalling - Without CTCSS encoder/decoder
- With CTCSS encoder/decoder
(Additional components on printed circuit board).
- Standard Selcall
- High performance Selcall
(Additional components on printed circuit board).
viii) Systems: - Standard no systems interface
- Systems interface.
(Additional components on printed circuit board).
1.1.2 Product Family
The PRM80 is provided with a family of product related ancillaries for standard vehicular
installation and base or office environment application.
The ancillaries are:
i) Desk top housing with mains power supply.
ii) Stand microphone.
iii) Boom microphone.
iv) Hands-free microphone.
v) Small loudspeaker.
Section 1 Page 2
To Next Page
Loading...