4. Advanced operation
• Image source: DVI2
• Aspect ratio: Aspect
• Color temperature: Calibrated
• Display function: CAL. DICOM
Settings menu:
• OSD menu position: Bottom right
• OSD menu time-out: 15 sec.
• OSD lock: On
• Power (5V) over DVI1: Off
• Power (5V) over DVI2: PIN 14 ON
• +5 VDC power output: On
• Back illumination: On
Brightness setting: 100%
To reset the OSD menu settings
1. Bring up the OSD main menu.
2. Navigate to the Settings menu.
3. Select Factory reset.
Info
Image
Settings
OSD Position
OSD Timeout
OSD Lock
Factory Reset
DVI1 5V
DVI2 5V
5V Output
Back Illumination
Bottom right
15 sec.
On
Off
PIN 14 ON
On
On
Image 4-10
4.10 Power o ver DVI
About power on DVI
This setting allows you to select on which pin of the DVI connector(s) that the +5 VDC supply is applied,
or to completely disable the +5 VDC over DVI.
To adjust the power on DVI
1. Bring up the OSD main menu.
2. Navigate to the Settings > DVI1 5V or DVI2 5V menu.
3. Select one of the available options.
K5902096 (451920611523) PS24FHDCR 08/03/2018
19
To Next Page
Loading...
