11
Speci cations
Wireless
• Frequency range : 2.403 to 2.479 GHz
• RF output power : 15 dBm
• RF output impedance : 50 ohm
Sound
• Total Output Power : 2 x 125W
(Home Theatre Mode)
• Output power (FTC) :
180W
Power
• Power supply : 110 – 240V AC,
50/60Hz
• Standby power consumption: < 1 W
• Power comsumption : 50W
Connectivity
• Rear Connections: Easy-Fit speaker
connectors
Dimensions
• Receiver dimensions:
126 x 131.5 x 126 mm
(W x H x D)
• Transmitter dimensions:
48.5 x 88.3 x 49 mm
(W x H x D)
• Receiver Weight : 1.19 kg
• Transmitter Weight : 0.08 kg
Troubleshooting
Problem Solution
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, rst check the points listed below before taking the system for
repair. If you are unable to remedy a problem by following these hints, consult
your dealer or Philips for help.
If the indicator on the
wireless transmitter blinks
continously for more than a
minute.
– The transmitter may have been swapped with
another transmitter supplied with other receiver.
– Turn off all connected devices.
– Turn on the connected home theatre system
– Press and hold the CONNECT button on the
transmitter for 5 seconds. Release the
CONNECT button.
– Turn on the wireless receiver.
rwss125_37_ENG.indd 11rwss125_37_ENG.indd 11 2007-04-17 9:43:33 AM2007-04-17 9:43:33 AM
To Previous Page
Loading...
