User Guide
26
Source switching
To record a Device menu item containing a source switching command, open the
Device menu, hold down the Right button (labeled Action) and tap the device you
want to switch to.
Ending with a device control panel
To end a macro with displaying a device, open the Device menu, hold down the
Left button (labeled Device) and tap the device you want.
Editing macros
You can edit any macro you have recorded.
1 Open the macro group that contains the macro.
2 Switch to Edit mode via the Mode button .
3 Tap the macro you want to edit.
The contents of the macro appear.
4 Edit the macro.
You can move or delete listed commands or you can record new commands.
You can also add delays to the macro (for example, to insert a short pause
between turning on a device and sending commands to it allowing the device
to warm up):
1 Tap Delay.
2 Tap or to decrease or increase the length of the delay.
Getting the maximum out of it
To Next Page
Loading...
