User Guide
33
The TV goes blank or the input source changes
■ The Device menu item might be programmed to switch the input source.
Operate the device without affecting the input source (see p. 9).
The Remote Control won’t edit, label or delete commands
■ If the label locked appears on the Remote Control icon, the device control
panels have been locked to prevent unwanted changes. You cannot modify or
delete commands for this device.
■ Make sure your devices are positioned as shown on page 15. Avoid
programming the Remote Control under bright fluorescent light: it might affect
the infrared signals.
■ Make sure the button you want to edit has a border. Borderless buttons cannot
be programmed.
The Remote Control won’t switch modes
■ When the batteries are low the Remote Control prevents you from switching
to customizing modes so that no customization can get lost. Replace the
batteries or recharge the battery pack (see p. 3).
The Remote Control is low on memory
■ The Remote Control displays a message to clean up the memory. The Remote
Control will do this by permanently removing devices and macro and timer
groups you have deleted.
Warning Cleaning up memory can take 10 minutes or longer. Never remove batteries
during the clean-up process. This might damage the configuration file resulting
in loss of your customized commands.
The configuration file is corrupted
■ When this very unlikely event occurs, you have to revert to the original
configuration. All your customized commands devices and macros will be lost
and you will have to reprogram your Remote Control.
Remote Control error messages
■ If one of the following error messages occurs, please contact your dealer or
the Philips customer service:
■ Can’t open configuration file
■ Configuration file error
■ No configuration file found
■ Invalid configuration file version
Troubleshooting
To Next Page
Loading...
