Philips SCD560 - Linking Parent Unit and Baby Unit

7
• The ‘link’ light on the parent unit starts
ashing red and the message ‘LINKING’
appears on the display.
• When the parent unit and baby unit are
linked, the ‘link’ light turns solid green. The
signal strength indicator and the message
‘LINKED’ appear on the display.
• If no connection is established within 10
seconds, the message ‘NOT LINKED’ on the
display alternates with ‘LINKING’. If still no
connection is established after 30 seconds,
the parent unit starts to beep and only the
message ‘NOT LINKED’ is shown.
4.2 Linking parent unit and
baby unit
1 Press and hold the on/off button 3 on the
baby unit for 2 seconds.
• The nightlight, the battery status light and
the power-on light go on briey.
2 Press and hold the on/off button 3 on the
parent unit for 2 seconds.
• The display goes on and briey displays all
indicators and symbols. Then the indicators
and symbols fade out and the battery status
indicator appears.
D
Note:
When you switch on the parent unit for
the rst time or after a reset, you have
to select your preferred display language
(see ‘Language’ in chapter ‘Menu of the
parent unit’).
2 sec.
ENGLISH