To Next PageTo Next Page
Need help?Do you have a question about the Philips SCD580 and is the answer not in the manual?
General| Brand | Philips |
|---|---|
| Model | SCD580 |
| Category | Baby Monitor |
| Language | English |
Use the baby unit from the mains. To guarantee automatic power backup in case of mains failure, we advise you to insert non-rechargeable batteries.
Put the adapter in a wall socket and insert the small appliance plug into the baby unit.
In case of mains failure the baby unit can run on four 1.5V R6 AA alkaline batteries (not included).
The parent unit runs on two rechargeable batteries that are supplied with the baby monitor.
Slide the lid of the compartment for the rechargeable batteries off the parent unit.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the batteries are low.
Keep the baby unit out of the reach of the baby. Never place the baby unit inside the baby's bed or playpen.
Press and hold the on/off button on the baby unit for 2 seconds.
In both standard operating mode with Smart Eco and in Eco Max mode, the operating range is 330 metres/1000 feet outdoors and up to 50 metres/150 feet indoors.
The parent unit has a separate soothing menu for all soothing features: nightlight, lullaby and projector.
When the baby unit runs on battery power and its batteries are low, the parent unit gives the following signals:
The battery charge status is indicated on the display by the battery status indicator and by text messages.
When the rechargeable batteries are low, the remaining operating time is at least 30 minutes if the baby monitor works in normal mode at the highest settings.
If the rechargeable batteries are almost empty, the battery status light flashes red quickly.
Insert the small plug into the charger and put the adapter in a wall socket. Place the parent unit in the charger.
