Philips SimplyGo Quick Start Guide

This guide is intended to help you get started using the SimplyGo
portable oxygen concentrator. If you have questions that are not
answered in this guide, please consult the SimplyGo User Manual
or contact your homecare provider.
Getting started
Charge the battery using the AC power cord.
Before using SimplyGo for the first time, the battery requires an
initial uninterrupted charging time of four hours minimum. This can
be accomplished by installing the battery (see step 2 of Quick-start
instructions) and using the AC power cord.
To charge the battery using the AC power cord provided with your
system, follow these steps:
1. Connect the AC power supply’s output cable to the SimplyGo power
input connector located on the upper right side of the unit.
2. Connect the AC power cord’s connector to the AC power supply.
3. Connect the AC power cord’s plug to an AC outlet.
Important: The first time you charge the battery, be sure to charge it fully.
Do not use the DC power cord for initial charge; instead use AC power.

Philips SimplyGo Specifications

General

Weight	10 lbs (4.5 kg) with battery
Dimensions	11.5 in x 10 in x 6 in (29.2 cm x 25.4 cm x 15.2 cm)
Operating Temperature	41°F to 104°F (5°C to 40°C)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Flow Settings	Continuous flow and pulse dose settings
Maximum Oxygen Output	2 LPM continuous flow
Power Source	AC, DC, or rechargeable battery
Operating Altitude	Up to 10, 000 feet (3048 meters)
Humidity Range	15% to 95% (non-condensing)
Charging Time	Approximately 2 to 3 hours