Philips sonicare 2000 Series - Inserting and removing nozzles; Using your Cordless Power Flosser

13
English
Inserting and removing nozzles
Insert your preferred nozzle into the handle. Press the
nozzle down until you hear a "click".
Note: Ensure the nozzle is fully inserted and flush with
the top of the device.
2
1
To remove the nozzle, press the nozzle release button
and pull the nozzle from the handle.
Using your Cordless Power Flosser
1
Before turning on the device, point the nozzle tip at
the sink. Press the on/off button on the handle to turn
on the Cordless Power Flosser. Allow water to spray
into the sink. Turn off the device once water dispenses
from the device.
2
Place the nozzle tip in your mouth. Lean over the sink
and partially close your lips over the nozzle tip to
avoid splashing. Leave enough space to allow water
to flow from your mouth into the sink.
3
Press the on/off button on the handle to turn on the
Cordless Power Flosser.
4
With the Cordless Power Flosser turned on:
Note: Do not press nozzle release button while using.