14.2 Restore previous firmware
After the firmware of is upgraded, you can restore it to its previous version as desired.
On
1 Press MENU to enter the menu screen.
2 Use 3 or 4 and 2 to enter Settings followed by Firmware, then Restore firmware.
3 Press 2 to select Ye s .
After upgrading or restoring the firmware of , you need to reestablish the Wi-Fi connection
between and .
14.3 Re-establish Wi-Fi network of Center ( ) and Stations ( )
On :
1 Press MENU to enter the menu screen.
2 Use 3 or 4 and 2 to enter Station Mgnt menu.
3 Use 3 or 4 and 2 to select Add New Station.
> Searching for Stations starts.
On :
1 Disconnect the power plug of and then connect them to the power supply again.
> Connecting to Center appears.
2 Press MENU on the remote control to enter the selection screen of Installation Mode and
Select Server.
3 Use 3 or 4 and 2 to enter Installation Mode.
> Stations start to connect to .
4 Press STOP 9 on when all are found.
Reset
81
ENGLISH
To Next Page
