Philips System 21 - Page 15

Function I Command Description Default See
Operating mode
•
"Mn"
Select operating mode n .
7
Functional command (slave command)
•
"CLOSE 1"
Example of a functional 7
command. These commands are
unit specific and are
only handled
in the operating cards of the
different
slave units.
Pre-programming
8.1
•
"Pn, cmd, ... , cmd" Functional commands
8.2
"cmd, ... . , cmd" are stored on
memory position n (n=0 ... 19).
Block-memory clear memory
8.3
cleared
•
"Pn"
Clears memory position n .
•
"Pn-m"
Clears
memory position n up to 8.3
including m, where
O<=n<m<=19 .
•
"R2"
Clears all memory positions. 8.3
Initiating 8.1
•
"In"
Initiate block-memory position n
8.4
•
"I
~B [,n]"
Initiate block
operation, up to and
8.4/
including memory position n. 8.8
•
"I~S"
Initiate a scan (see "scan
8.9
function).
Set trigger mode
Sys.M
0
" TRG~R " TRiGger if Ready mode: enable
Sys.M
the trigger-commands GET and
"XCU T" only when the ready-
line is true or delay the received
trigger command
until the ready-
line becomes true.
0 "TRG~U"
TRiGger Unconditional mode: "TRG R"
Sys.M
the trigger-commands GET and
" XCU T" will unconditionally gene-
rate an impulse on the trigger-line.
15