Function I Command
Description
Default
See
Set
execution mode
8.5
•
"E~U"
Execute Unconditional mode.
"E
U"
8.5
This mode is not allowed for
block and scan operations.
•
"
E._)("
Execute on command
"X"
mode.
8.5
.
•
"E~T"
Execute on trigger mode (low
8.5
impulse on the trigger-line).
Trigger and execute commands
8.5
•
"X"
eXecute (if in " E
X"
mode).
8.5
0
IEC TRIGGER #
11
J
Statements for P2000C and HP85
8.6
0
TRIGGER
711
to generate a
GET
(Group Exe-
8.6
cute Trigger). Generates a
pulse
on the System
21
trigger-line if
enabled (see
"Set
trigger mode"
).
0
"
XCU~T
"
eXeCUte the units by a pulse on
8
.6
the System
21
trigger-line if
enabled (see "Set trigger mode").
0
"XCU
nn"
eXeCUte all units with "PM21nn"
8.7
numbers independent on the
execution mode of the units. This
command is
useful when using
"I
~S
"
commands to perform a
scan by more than one unit of the
same type number.
Block operation
8.8
•
"
1~8
[,n]"
Initiate block operation,
up
to
8.8
and including memory position n.
This command is to be
followed
by a repetitive execute command.
Each execute command executes
the present
block-memory
position and initiates a next o
ne
.
The Execute
Unconditional mode
"
E~U
"
is not allowed here.
16
To Next Page
Loading...
