EasyManua.ls Logo

Philips TAB4208/37 - Placement; Wall Mount

Philips TAB4208/37
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9EN
Placement
Wall mount
Note
4mm/
0.16"
>33mm/1.3“
2.5-3.0mm/0.1-0.12”
Do not place the remote control on a
wet object.
Do not place the remote control under
direct sunlight or near sources of
excessive heat.
Remove the battery from the remote
control when not in use for a long
period of time, as corrosion or battery
leakage may occur and result in
physical injury, and/or property

Do not use any batteries other than

Do not mix new batteries with old
ones.
Never recharge a battery unless it is

Improper wall mounting may result in accident,
injury or damage. If you have any query, contact
Consumer Care in your country.
Before wall mounting, make sure the wall can
support the weight of your soundbar.
Before wall mounting, you need not remove the
rubber feet at the bottom of the soundbar,

Depending on the type of wall mounting, make
sure that you use screws of a suitable length and
diameter.
Please check whether the USB port on the back of
the soundbar is connected to a USB device. If it is

wall-mount, you need to use another USB device
of the appropriate size.
Screw length/diameter
Suggested wall mounting height
You are recommended to install the TV

With a TV preinstalled, wall mount the
soundbar 50mm/2.0’’ in distance from
the bottom of the TV.
To prevent injury, this apparatus must be securely

installation instructions.
 
Place your soundbar as shown below.
WARNING !

Related product manuals